Useful

Extractor hood: how to install it?

Extractor hood: how to install it?

An extractor hood is an essential element in a kitchen since it eliminates cooking odors and vapors. At the same time, it limits the accumulation of dirt on the kitchen walls and ceilings. So that the hood keeps a decorative appearance on your wall, know that it can be connected to a duct. We will then have a direct extraction, but the hood can also operate in recycling after filtration. Find more articles on the theme: Work quotes for a kitchen installation

Installing an extractor hood: the necessary equipment

The elements you need to install your extractor hood are as follows: an extractor hood, an expandable duct made of compacted aluminum, two hose clamps and a non-return valve if not supplied. At the level of the tools, take a meter, a pencil, a spirit level, an impact drill, a hammer, a screwdriver, a drill-driver and d 'a stepladder.

Where to install your extractor hood?

Use the middle of the baking sheet as a starting point, you must then draw a vertical line with the spirit level by extending it to the ceiling. On this axis, make a trace of 65 or 70 cm above the hob.

Fixing the hood

Here you must refer to the operating instructions for the hood which will provide you with the fixing dimensions which you will have to put on the wall. Then you will drill and peg depending on the nature of your wall. Once the holes are made, you will screw the telescopic cover flanges. The hood will then be engaged on its supports. You will then remove the filters and grids to access the anchor points so that you can fix it.

The power supply of the hood

In order to maintain an aesthetic side to the hood, it is advisable to provide an outlet or a connection box, which will be hidden by the covering of the chimney. This trick makes it possible to hide the box or the wires while leaving it accessible.

The creation of the exhaust duct for your hood

Regarding the connection, make sure that the outlet of the hood is equipped with a non-return valve which is fixed on the nozzle. You will then connect the expandable compacted aluminum sheath. If desired, it can be reinforced with a screw collar. With regard to the telescopic casing, you will have to install the hood glass and the two duct casing elements. Here you will follow the instructions provided in the instructions.

Commissioning the extractor hood

You just have to place the metal filters and check if the lighting and extraction speeds work well.